Digital Monitoring XR5 Guía de usuario descargar pdf (Pagina 17)

LED Keypad User’s Guide

XR5 User’s Guide

Testing the System

It is good practice to test your system at least once each week.

This assures you that the system is working correctly and

identi es any potential problems.

Enter COMMAND + 4 + 1 to perform a system test. The bell

rings for 2 seconds then the battery and communications to the

central station are tested.

You can also initiate a System Test by pressing the TEST function

key followed by your User Code.

User Codes

Use this function to change the current User Code.

Press the CODE key followed by the current User Code. You

hear one beep if successful. Enter 0 (zero) + 1. Enter the new

4-digit User Code.

2-Button Fire Keys

If your system has a label showing a  ame under the TEST

and CODE keys, the optional Fire Panic key function has been

enabled.

Press the two keys over the icon, and hold them down for at

least 2 seconds. The system sends a Fire report to the central

station. The keypad beeps to con rm the Fire key entry.

SPECIAL

Pressing the

SPECIAL

key and entering the user code initiates

the Fire Drill function.

The Fire Drill sounds the alarm bells and keypad sounder for the

duration of the Bell Cutoff time. If the Bell Cutoff time is set to

zero (0), the Fire Drill continues until the bells are silenced by

entering a code. No keypad LEDs are turned on and no reports

are sent to the central station during the Fire Drill.

In the event of a real  re during a  re drill, the system sends a

report to the central station and the LED for any  re-detecting

zone glows red on the 692F.

Manual Fire Alarm

To manually initiate a Fire Alarm, press and hold the

TEST

and

CODE

keys simultaneously for about 2 seconds until the alarm

sounds.

Resetting Sensors

Use this function to reset smoke detectors after an alarm when

the Fire zone light is  ashing in alarm memory.

Enter COMMAND

+ 4 + 7

to perform a Sensor Reset. The system

resets the smoke detectors and stops the  ashing light if the

zone restores to normal.

You can also initiate a Sensor Reset by pressing the RESET

function key followed by your User Code.

1 2 ... 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

Digital Monitoring XR5 Guía de usuario Pagina 17

Comentarios a estos manuales

Relacionado con productos y manuales para Detectores de humo Digital Monitoring XR5